Experimental Investigation and Optimisation of Flow Dynamics of Gravity Moving Bed Electric Heater for Olivine Particles in CSP

Particle Image Velocimetry (PIV) Study of a Gravity Moving Bed Electric Heater for Olivine Particles

Authors

DOI:

https://doi.org/10.52825/solarpaces.v4i.2999

Keywords:

CSP, Thermal Energy Storage, Moving Bed Heat Exchanger, PIV, Olivine, POWDER2POWER

Abstract

Solid-particle-based next-generation Concentrating Solar Power (CSP) holds promise for operating temperatures of 700–750 °C, enabling highly efficient sCO₂ cycles. Among solid-particle heat exchangers, gravity-driven moving bed designs are attractive due to their simplicity and low parasitic losses. In the EU-funded POWDER2POWER project, an electric superheater with tubular elements (OD 51 mm) is under development to provide additional particle heating using surplus PV electricity. However, granular flow around tubular elements are prone to stagnant and void zones, leading to reduced heat transfer and potential overheating risks. This paper presents the design of a transparent pilot-scale test rig and the experimental investigation of olivine flow dynamics using Particle Image Velocimetry (PIV). A series of experiments were conducted to evaluate the influence of tube spacing and geometry on particle velocity, void formation, and stagnant zones. Flow behaviour was studied for different rod spacings (70, 85, 100 mm) and compared against the baseline with the same outlet and resulting flow rate. Results confirm that 100 mm spacing produces significant flow maldistribution, while smaller spacing of 75 and 80 mm improves the particles’ velocity uniformity and allows a decrease in the size of stagnant zones. Average velocities ranged between 5-15 cm/s, with excessive speeds observed in some geometries. The findings provide design guidance for gravity-driven moving bed electric heaters and support prototype development within the POWDER2POWER project.

Downloads

Download data is not yet available.

References

[1] M. Mehos, C. Turchi, J. Vidal, M. Wagner, Z. Ma, C. Ho, W. Kolb, C. Andraka, A. Kruizenga, Concentrating Solar Power Gen3 Demonstration Roadmap, NREL/TP-5500-67464 (2017) 1–140. https://doi.org/10.2172/1338899. DOI: https://doi.org/10.2172/1338899

[2] S. Guccione, S. Trevisan, R. Guedez, B. Laumert, Thermodynamic Analysis of a Hybrid PV-Particle Based sCO2 Concentrating Solar Power Plant, AIP Conf Proc 2815 (2023) 30007. https://doi.org/10.1063/5.0149553. DOI: https://doi.org/10.1063/5.0149553

[3] P. Bartsch, T. Baumann, S. Zunft, Granular Flow Field in Moving Bed Heat Exchangers: A Continuous Model Approach, Energy Procedia 99 (2016) 72–79. https://doi.org/10.1016/J.EGYPRO.2016.10.099. DOI: https://doi.org/10.1016/j.egypro.2016.10.099

[4] K.J. Albrecht, H.F. Laubscher, C.P. Bowen, C.K. Ho, Performance Evaluation of a Prototype Moving Packed-Bed Particle/sCO2 Heat Exchanger, (2022). https://doi.org/10.2172/1887943. DOI: https://doi.org/10.2172/1887943

[5] Z. Ma, J. Martinek, Analysis of a fluidized-bed particle/supercritical-CO2 heat exchanger in a concentrating solar power system, Journal of Solar Energy Engineering, Transactions of the ASME 143 (2021). https://doi.org/10.1115/1.4048548. DOI: https://doi.org/10.1115/1.4048548

[6] P. Bartsch, S. Zunft, Granular flow around the horizontal tubes of a particle heat exchanger: DEM-simulation and experimental validation, Solar Energy 182 (2019) 48–56. https://doi.org/10.1016/j.solener.2019.01.086. DOI: https://doi.org/10.1016/j.solener.2019.01.086

[7] J. Izquierdo, C. Hagan, S. Cruz, Y. Lian, S. Atre, B. Bhatia, Particle flow optimization for moving bed heat exchangers, Appl Therm Eng 254 (2024) 123875. https://doi.org/10.1016/J.APPLTHERMALENG.2024.123875. DOI: https://doi.org/10.1016/j.applthermaleng.2024.123875

[8] W. Cao, F. Zhang, J. Hu, S. Yang, H. Liu, H. Wang, DEM Investigation on the Flow and Heat Transmission Characteristics of Multi-Size Particles Mixed Flow in Moving Bed, Processes 2024, Vol. 12, Page 408 12 (2024) 408. https://doi.org/10.3390/PR12020408. DOI: https://doi.org/10.3390/pr12020408

[9] Y. Forterre, O. Pouliquen, Flows of dense granular media, Annu Rev Fluid Mech 40 (2008) 1–24. https://doi.org/10.1146/ANNUREV.FLUID.40.111406.102142. DOI: https://doi.org/10.1146/annurev.fluid.40.111406.102142

[10] W. Thielicke, E.J. Stamhuis, PIVlab – Towards User-friendly, Affordable and Accurate Digital Particle Image Velocimetry in MATLAB, J Open Res Softw 2 (2014). https://doi.org/10.5334/JORS.BL. DOI: https://doi.org/10.5334/jors.bl

[11] W. Thielicke, R. Sonntag, Particle Image Velocimetry for MATLAB: Accuracy and enhanced algorithms in PIVlab, J Open Res Softw 9 (2021) 1–14. https://doi.org/10.5334/JORS.334. DOI: https://doi.org/10.5334/jors.334

[12] M. Raffel, C.E. Willert, F. Scarano, C.J. Kähler, S.T. Wereley, J. Kompenhans, Particle Image Velocimetry: A Practical Guide, Third Edition, Particle Image Velocimetry: A Practical Guide, Third Edition (2018) 1–668. https://doi.org/10.1007/978-3-319-68852-7. DOI: https://doi.org/10.1007/978-3-319-68852-7_1

Downloads

Published

2026-10-20

How to Cite

Koturbash, T., Myrvoll, C., Turås, E., & Lannoy, Q. (2026). Experimental Investigation and Optimisation of Flow Dynamics of Gravity Moving Bed Electric Heater for Olivine Particles in CSP: Particle Image Velocimetry (PIV) Study of a Gravity Moving Bed Electric Heater for Olivine Particles. SolarPACES Conference Proceedings, 4. https://doi.org/10.52825/solarpaces.v4i.2999
Received 2025-09-25
Accepted 2026-05-26
Published 2026-10-20

Funding data